Pedal crank arm flush with bike body

[geodrome]

I'm looking at this bike, but the pedal crank arm is flush with bike body. Would the VZFit sensor work if attached in the short bit between the bike body and where you put your feet? Or should I choose another model?

Here's the model. (Sorry - it's in Russian, but just open the first pic)

https://svensson-body-labs.ru/catalog/ve...ine-bta-2/

[Snowpelt]

Hey Geo,

Looking at some videos of this bike, if you used some two sided tape to mount the sensor on the wheel where the pedal crank connects it should work fine. Just mount the sensor so that it's flat and level when the wheel is down. This is similar to how you would mount the sensor on an elliptical.

[geodrome]

Hey Geo,

Looking at some videos of this bike, if you used some two sided tape to mount the sensor on the wheel where the pedal crank connects it should work fine. Just mount the sensor so that it's flat and level when the wheel is down. This is similar to how you would mount the sensor on an elliptical.

Thanks!