Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
vzFit hardware
#4
Was your VZ Bike resistance always too easy on the hardest setting, or did it get easier? If you're up for it, you can unscrew the two sides of the pedal housing to reveal the magnetic resistance arm under the flywheel. There's a screw connecting the arm to a wire that goes to your resistance knob. You can loosen that screw and move the wire and retighten to adjust the resistance. The closer the arm is to the flywheel, the harder the resistance, so you'll want it really close when the resistance knob is at 8. So close that you'll need a nickel or other coin to space it from the flywheel when you retighten the wire, it's impossible to hold it that close by hand and not let it touch the flywheel while retightening.
Reply


Messages In This Thread
vzFit hardware - by peteostro - 05-09-2019, 04:39 PM
RE: vzFit hardware - by jwarburg - 05-09-2019, 06:52 PM
RE: vzFit hardware - by peteostro - 05-09-2019, 07:41 PM
RE: vzFit hardware - by emalafeew - 05-10-2019, 07:34 PM

Forum Jump:


Users browsing this thread: 4 Guest(s)