Button will not connect after updating

[Islareina]

Hello, I'm interested to know if anyone else has had any difficulties after the last update?

I am using Oculus Go.  I went to use VZFit as usual the other day but I had to wait for it to update.  After the update it says "Press A to Connect Button" as usual, but this time the button would not connect.  I waited a few days and tried again this morning, still no-go. (there is no message to "start pedaling," I can't get that far)

The battery is fairly new (just about a month) and I can see the blue light on the button controller blink when I press "A."  I've tried to press "B", and the volume buttons, I've tried to use VZ Explorer and still nothing.  I have a battery in the wings to change as a last resort, but before I did I wanted to know if there was anyone else with the same experience, and if you have any suggestions.

Thanks for your time!

[emalafeew]

If the volume buttons aren't working either it's an Oculus level problem. Try un-pairing and re-pairing the Button to your Go through the Oculus app.

[Islareina]

If the volume buttons aren't working either it's an Oculus level problem.  Try un-pairing and re-pairing the Button to your Go through the Oculus app.

That did it, thank you!