Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Pedal crank arm flush with bike body
#3
(10-16-2020, 06:50 PM)Snowpelt Wrote: Hey Geo,

Looking at some videos of this bike, if you used some two sided tape to mount the sensor on the wheel where the pedal crank connects it should work fine. Just mount the sensor so that it's flat and level when the wheel is down. This is similar to how you would mount the sensor on an elliptical.

Thanks!
Reply


Messages In This Thread
RE: Pedal crank arm flush with bike body - by geodrome - 10-18-2020, 07:54 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)